A Model of Dual Fabry-Perot Etalon-Based External-Cavity Tunable Laser Us...
Internal motion within pulsating pure-quartic soliton molecules in a fibe...
Enhanced light emission of germanium light-emitting-diode on 150 mm germa...
The Fabrication of GaN Nanostructures Using Cost-Effective Methods for Ap...
Negative-to-Positive Tunnel Magnetoresistance in van der Waals Fe3GeTe2/C...
Quantum Light Source Based on Semiconductor Quantum Dots: A Review
A High-Reliability RF MEMS Metal-Contact Switch Based on Al-Sc Alloy
Development of a Mode-Locked Fiber Laser Utilizing a Niobium Diselenide S...
Development of Multiple Fano-Resonance-Based All-Dielectric Metastructure...
Traffic Vibration Signal Analysis of DAS Fiber Optic Cables with Differen...
官方微信
友情链接

Laser slicing of 4H-SiC wafers based on picosecond laser-induced micro-explosion via multiphoton processes

2022-07-15

 

Author(s): Han, SF (Han, Shifei); Yu, HJ (Yu, Haijuan); He, CJ (He, Chaojian); Zhao, SS (Zhao, Shusen); Ning, CY (Ning, Chaoyu); Jiang, L (Jiang, Lu); Lin, XC (Lin, Xunchun)

Source: OPTICS AND LASER TECHNOLOGY Volume: 154 Article Number: 108323 DOI: 10.1016/j.optlastec.2022.108323 Published: OCT 2022

Abstract: Silicon carbide has many advantages and a wide range of applications. The fabrication of a thin silicon carbide wafer using diamond wire cutting has become problematic because it resulted in chipping, delamination, and heating. In this work, it is proved that the 1064 nm picosecond laser creates a multiphoton-induced micro-explosion in 4H-SiC, which confined the microburst layer near the focus of the laser beam and made a cutting width of less than 2 mu m. As a result, the 4H-SiC was decomposed into amorphous Si and C owing to the transient high temperature generated. Optimized processing parameters were investigated, such as the etching speed v and etching interval d at the optimized pulse energy of 30 mu J and a laser repetition frequency of 100 kHz. Eventually, two 4H-SiC wafers were successfully manufactured, which have an area of 1 cm x 1 cm and a thickness of 250 mu m without residual stress on the sliced surface. The wafer minimum surface roughness was approximately 1.8 mu m with a standard deviation of <= 0.12 mu m. The structure and composition of 4H-SiC were investigated after laser slicing. This technology has critical applications for slicing hard and brittle material and thinning many semiconductors devices' backsides.

Accession Number: WOS:000817739700002

ISSN: 0030-3992

eISSN: 1879-2545

Full Text: https://www.sciencedirect.com/science/article/pii/S0030399222004807?via%3Dihub



关于我们
下载视频观看
联系方式
通信地址

北京市海淀区清华东路甲35号(林大北路中段) 北京912信箱 (100083)

电话

010-82304210/010-82305052(传真)

E-mail

semi@semi.ac.cn

交通地图
版权所有 中国科学院半导体研究所

备案号:京ICP备05085259-1号 京公网安备110402500052 中国科学院半导体所声明