A Model of Dual Fabry-Perot Etalon-Based External-Cavity Tunable Laser Us...
Internal motion within pulsating pure-quartic soliton molecules in a fibe...
Enhanced light emission of germanium light-emitting-diode on 150 mm germa...
The Fabrication of GaN Nanostructures Using Cost-Effective Methods for Ap...
Negative-to-Positive Tunnel Magnetoresistance in van der Waals Fe3GeTe2/C...
Quantum Light Source Based on Semiconductor Quantum Dots: A Review
A High-Reliability RF MEMS Metal-Contact Switch Based on Al-Sc Alloy
Development of a Mode-Locked Fiber Laser Utilizing a Niobium Diselenide S...
Development of Multiple Fano-Resonance-Based All-Dielectric Metastructure...
Traffic Vibration Signal Analysis of DAS Fiber Optic Cables with Differen...
官方微信
友情链接

4-Channel, 100 Gbps Inductorless Optical Receiver Analog Front-End in CMOS for Optical Interconnect

2021-10-08

 

Author(s): Zhou, GL (Zhou, Gaolei); Mao, XR (Mao, Xurui); Xie, S (Xie, Sheng); Cai, HC (Cai, Haocheng)

Source: IEEE ACCESS Volume: 9 Pages: 131780-131788 DOI: 10.1109/ACCESS.2021.3114499 Published: 2021

Abstract: In this paper, a 4-channel, 100 Gbps inductorless optical receiver analog front-end fabricated in a 55 nm bulk-CMOS technology is presented. Active feedback technique is widely adopted to improve the performance of the optical receiver without the area-occupied inductors. To alleviate the voltage headroom stress of the local feedback loop in traditional regulated cascode transimpedance amplifier, the common gate amplifier is inserted before the traditional common source feedback stage. And the cross-couple active feedback stage provides a negative signal path to extend the bandwidth of the local feedback loop. Multistage limiting amplifier with active negative and positive feedback stages are employed to extend bandwidth and acquire high gain simultaneously. The optical receiver was realized as 4-element arrays occupying the area of 800 mu m x 1800 mu m, whereas the core area of each channel is just 275 mu m x 650 mu m. The measured 3-dB bandwidth reaches 22.8 GHz, sufficient for 25-Gbps operation. For an input voltage of 2.5 mV(p-p), the optical receiver achieves a BER = 10(-12) at 25-Gbps PRBS7, and 310 mV differential output voltage is delivered. From the supply voltage of 1.2 V, the test chip consumes the power of 226 mW and exhibits the power efficiency of 2.3 mW/Gb/s, when 25-Gbps PRBS31 is supplied.

Accession Number: WOS:000701233100001

ISSN: 2169-3536

Full Text: https://ieeexplore.ieee.org/document/9543696



关于我们
下载视频观看
联系方式
通信地址

北京市海淀区清华东路甲35号(林大北路中段) 北京912信箱 (100083)

电话

010-82304210/010-82305052(传真)

E-mail

semi@semi.ac.cn

交通地图
版权所有 中国科学院半导体研究所

备案号:京ICP备05085259-1号 京公网安备110402500052 中国科学院半导体所声明