A Model of Dual Fabry-Perot Etalon-Based External-Cavity Tunable Laser Us...
Internal motion within pulsating pure-quartic soliton molecules in a fibe...
Enhanced light emission of germanium light-emitting-diode on 150 mm germa...
The Fabrication of GaN Nanostructures Using Cost-Effective Methods for Ap...
Negative-to-Positive Tunnel Magnetoresistance in van der Waals Fe3GeTe2/C...
Quantum Light Source Based on Semiconductor Quantum Dots: A Review
A High-Reliability RF MEMS Metal-Contact Switch Based on Al-Sc Alloy
Development of a Mode-Locked Fiber Laser Utilizing a Niobium Diselenide S...
Development of Multiple Fano-Resonance-Based All-Dielectric Metastructure...
Traffic Vibration Signal Analysis of DAS Fiber Optic Cables with Differen...
官方微信
友情链接

Photonic 2-D angle-of-arrival estimation based on an L-shaped antenna array for an early radar warning receiver

2021-01-14

 

Author(s): Lin, T (Lin, Tao); Zhang, ZK (Zhang, Zhike); Wang, YH (Wang, Yuehui); Zhu, ZH (Zhu, Zihang); Zhao, SH (Zhao, Shanghong); Liu, JG (Liu, Jianguo); Jiang, W (Jiang, Wei); Wu, GZ (Wu, Guozhang)

Source: OPTICS EXPRESS Volume: 28 Issue: 26 Article Number: 412164 DOI: 10.1364/OE.412164 Published: DEC 21 2020

Abstract: Early radar warning is a significant step to lessen the fine scanning range of a receiver. The small size two-dimension (2-D) angle-of-arrival (AOA) estimation part with moderate accuracy and sensitivity is important for an early radar warning receiver. In our method, we specially design an L-shaped antenna array (L-sAA) and connect it with dual-polarization binary phase shift keying modulator (DP-BPSKM). The dual-sideband (DSB) modulation is performed to transfer most of the optical power to electrical, so as to increase the sensitivity. It is also possible to map the AOA information of the incoming beam to photo-detected electrical power without a high extinction ratio modulator or optical filter. During the estimation, the 2-D AOA is firstly measured, whose measurement range is 18.22 degrees similar to 90 degrees and the measurement error is lower than 1 degrees. Then, based on the 2-D AOA estimation results, the third one is mathematically calculated to construct 3-D location of the target. Noteworthy, the amplitude comparison function (ACF) is adopted in this method to make the system response irrelative to the received signal power, which endows the system with signal power fluctuation immunity. Experimental results show that this method is capable of measuring a single-tone signal and a bandwidth signal. This structure is very concise and meets the potential of on-chip integration. (C) 2020 Optical Society of America under the terms of the OSA Open Access Publishing Agreement

Accession Number: WOS:000600667300040

PubMed ID: 33379454

ISSN: 1094-4087

Full Text: https://www.osapublishing.org/oe/fulltext.cfm?uri=oe-28-26-38960&id=444664



关于我们
下载视频观看
联系方式
通信地址

北京市海淀区清华东路甲35号(林大北路中段) 北京912信箱 (100083)

电话

010-82304210/010-82305052(传真)

E-mail

semi@semi.ac.cn

交通地图
版权所有 中国科学院半导体研究所

备案号:京ICP备05085259-1号 京公网安备110402500052 中国科学院半导体所声明